ProSound
Remote Control and Diagnostic Features
when Installed on Rokonet Systems’ Bus
● Remote reading of input voltage level
● Measurement of input charge current
● Remote speaker current level (when
speaker is active)
● Remote battery voltage level
measurement
● Initiate battery load test
● Programmable strobe flashing
frequency (20 to 60 times/minute)
● Adjustable anti-foam attack sensitivity
15
Status LED
Surface Light Technology
(SLT™) Strobe
Vandal-proof
double-skin metal cover
Specifications
Input voltage and current 13.5 to 14.2 VDC, 200mA maximum
Standby current consumption 54mA + battery charge current
Battery charge current 140mA maximum
Operating current (Siren + Strobe) 1A nominal (1.6 A maximum)
Speaker Sound level 106 dBA at 3 meters
Tone frequency 1500-1800 Hz
Strobe light Surface Light Technology SLT™ with 6000 mcd
Strobe lens Polycarbonate
Strobe flash rate 60 times per minute
Backup battery (not supplied) SLA (Sealed Lead Acid) rechargeable, 12V, 2.2 Ah,
UL approved, Size (L x H x W): 178 x 64 x 35 mm
Battery discharge protection Automatic disconnection below 10.5 VDC
Ingress protection IP 34 rating
Operational temperature -25ºC to 70ºC (-13ºF to 158ºF)
Humidity 95% maximum
Housing material Polycarbonate with UV protection
Tamper contact 0.5A, 24V, termination NC or internal EOL resistor
Anti-foam contact 0.1A, 24V, NC termination
Dimensions (H x W x D) 305 x 218 x 116 mm
Weight (without battery) 2.03 kg
Compatibility All control panels
Rokonet systems compatibility 4 wire RS485 bus, up to 300m from main panel
ProSound Features
● Long-life SLT™ strobe (patent pending) combined with 106 dBA sounder
● Unique anti-foam, anti-drilling and anti-approach protection (patent pending)
● UV-treated weatherproof and vandal resistant polycarbonate housing
● Double skin with internal metal cover
● Simple installation and maintenance
● Remote Control and Diagnostics when connected to Rokonet’s systems
● Input protected against polarity reversal, interferences and over-voltages
● Negative and positive triggering inputs
● Auto-recharging battery circuit
● Automatic battery disconnection prevents battery deep discharge
● Battery enables 36-hour backup or 80 minutes alarm
● Wall and cover tampers with internal EOL resistor
● Arm/Disarm and alarm memory indications via status LED
Comments to this Manuals