Rokonet ORBiT-14 User Manual download pdf (Page 63)

Installation and Programming Manual

3) Utility Outputs

By adding one or more Utility Output Expansion Modules to the system, an extensive list of switched output

possibilities become available. After selecting a System Event used to trigger the intended Utility Output, press

[ENTER] to select the desired PATTERN OF OPERATION, and its duration.

The programming parameters found in this section allow you to choose the event that will trigger a selected

Utility Output, along with the manner in which the output will be applied.

With the display showing:

press [ENTER] to begin.

With the display showing:

enter the two-digit number of the Utility Output you wish to program, using a “leading zero” for numbers between 1

and 9 (e.g. 01, 02, etc.) and press [ENTER].

At this time, you’re ready to program the selected Utility Output using the information found in the table below.

Keep in mind that each of the system’s Utility Outputs may be assigned to a single type of event–relating to

activities in one of four major categories.

• the System • a Zone

• a Partition • use of a User Code

Quick Key Utility Output Follows Default Explanation

NOTHING

disables the selected Utility Output

SYSTEM

--- § the Utility Output will follow the chosen

System Event, selected among those listed

below:

§ after making your selection, press [ENTER]

§ proceed to PATTERN of OPERATION, on page

69.

Bell Follow

---

activates when an alarm is triggered

No Telephone Line

---

activates when a telephone line problem is detected

Communication

Failure

---

activates when successful communication with the

Central Station cannot be achieved

§ activates when a system trouble condition is

detected

§ troubles include those found in the system’s

general operation as well as those unique to an

Expansion Module

§ detectable troubles in this category include:

§ Bell Circuit fault § Fire Loop trouble

§ loss of Auxiliary Power § Phone Line failure

§ 4-wire BUS failure § Clock not set

Trouble Follow

---

§ False Code trouble

INSTALL PROG:

3)UTIL OUTPUT ××

SELECT UO NUMBER

UO=01 (0:1)

UO=01 FOLLOWS:

0)NOTHING ↓↓

INSTALLER PROG:

3) UO ↓↓

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Comments to this Manuals

No comments

Rokonet ORBiT-14 User Manual Page 63

Comments to this Manuals

Related products and manuals for Security access control systems Rokonet ORBiT-14