Rokonet Orbit-6 User Manual download pdf (Page 12)

Installer Manual

Locations Whose Contents Occupy More Than One Digit

When a location contains more than one digit, they cannot be viewed

simultaneously. As soon as a location is accessed, the first digit is displayed

automatically. Additional digits (if they exist) can be displayed by pressing the

following keys:

Used to display the next digit in a location containing at least two

digits; e.g. if 5-6-7-8 is stored in a location, the “5” is displayed first;

by pressing , the “6” will be displayed; continue this

process to display the entire contents of the chosen location. Error

beeps will be produced when it’s attempted to display digits which

don’t exist

Used to move backwards among the digits stored in a location

containing at least two digits. Error beeps will be produced when it’s

attempted to display digits which don’t exist

Audible Tones and Error Beeps

To confirm an operation, a single, long beep will be heard. However, any improper use

of the keypad resulting in an error or an unacceptable response will produce three

rapid beeps. If heard, repeat the operation or exit the programming mode and try again.

How to program installer parameters

1. To enter the Installer programming mode:

Press 4 digit Installer code followed by # (factory default 0 2 0 6)

2. To move to a new location:

Press two digits of location followed by ARM

3. To enter data into the location:

Press data digits (0 - 9 digits including hexadecimal A-F) followed by #

4. To exit programming mode:

Press 4 digit installer code followed by ARM

A Programming Tutorial

To get acquainted with some programming basics, a short tutorial has been

prepared. It involves changing the Installer Code from the factory default of 0-2-0-

6 to a sequence of your own choosing. If you can master this operation,

subsequent programming should be easy.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

No comments

Rokonet Orbit-6 User Manual Page 12