Rokonet Orbit-6 User Manual download pdf (Page 25)

Installer Manual

Location: 28 CS Protocols:

When selecting a contact ID & SIA format, all the reporting codes will be automatically

applied to the locations of the reporting codes.

To change a code, enter a new code (according to the type of event – see page 30) to the

corresponding location.

When selecting the Pulsed Protocol the default for all the reported codes will be “00” and

any other code should be entered manually

To remove a particular reporting code from any of the 3 Protocols enter “00” into the

corresponding location.

Important: Choose the code format only after defining the zone parameters. Changing a

zone type after selecting the code format WILL NOT change the zone’s reporting code and

a faulty report will be sent to the central station.

Digit Format Name Interdigit Time Data Frequency

00 Pulsed Protocol

01 Contact ID NA NA

02 SIA 390 ms 1800 Hz

**03

(Ver. 1.3)

Ademco 4/2 Express

Upload/Download Rings: Location 29

Location 29 sets the number of rings that the ORBIT-6 will wait before automatically

answering an incoming call. If such a call was initiated by the alarm company’s

Upload/Download software, a process begins which allows a Remote Programming

session to take place.

Location: 29 Number of Rings Default: 12

Choose a number of rings greater than that which the customer will normally wait to answer

an incoming call enter two digits; (between 00-15 rings)

Note: if an Answering Machine is in use and so programmed

(see Location 26 / 2

Digit), entries made in this location will be ignored

SYSTEM CONTROLS: LOCATION 30

Location 30 allows you to specify some additional parameters, which determine how the

ORBIT-6 will operate. The location contains two digits.

• First digit: determine the number (or letter) corresponding to the choices involving

Quick Arm / Quick Bypass / UO Extender / Loudspeaker / Bell-Siren

• Second digit: determine the number (or letter) corresponding to the use of

Silent Panic / Bell Squawk on Arming / 3 Minute Bypass

Comments on System Controls (Location 30: 1

Digit)

Quick Arm Quick Bypass UO Extender Loudspeaker/Bell-Siren

Quick Arm

eliminates the

need for entering

a User Code when

arming to the STAY

or AWAY modes.

simply pressing

[STAY] or [ARM] will

arm the system to

the respective mode

Eliminates the

need to enter a

User Code when

bypassing a zone.

select UO Extender

if the Utility Output

Expansion Module is

installed

select Loudspeaker if the

external sounder(s) is NOT

equipped with a built-in sound

driver; doing so causes the

ORBIT-6 to produce an

oscillating frequency for the

device, select Bell/Siren if the

external sounder(s) is a bell or

a buzzer or equipped with a

built-in electronic sound driver;.

Number

of Rings

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Comments to this Manuals

No comments

Rokonet Orbit-6 User Manual Page 25

Comments to this Manuals

Related products and manuals for Security access control systems Rokonet Orbit-6