Rokonet Orbit-6 User Manual download pdf (Page 9)

Installer Manual

INSTALLER PROGRAMMING

The keypad

The Orbit-6 can support up to 4 keypads, with

a choice of 3 styles, 1 LCD type and two LED

types from which virtually all features may be

accessed. In addition to the functions it

provides for the user, each of the keypads can

be used by an installer to program the system

parameters.

An attempt to enter an incorrect series of

keystrokes will result with 3 error beeps.

All program location values (data) are

displayed by zone indicators on the LED

keypad in binary format.

Restoring Factory Defaults to the ORBIT-6

1. Your ORBIT-6 and at least one LED Keypad should already be wired together

and/or physically installed

2. Remove all power from the Printed Circuit

3. Place the ORBIT-6’s J1 (DEFAULT) jumper over both corresponding pins. (See

Figures 1A and 1B on page 32 and 33 ).

4. Reapply power (AC and/or Standby Battery) to the PC Board.

5. After a short beep is heard, remove the J1 jumper. The ORBIT-6’s default settings

are now restored.

6. Check that the POWER LED is flashing. Depending on the state of the system, the

READY LED and the Zone LEDs may or may not be lit.

Introduction to Programming

First, check that the panel’s J1 (DEFAULT) jumper is NOT covering both pins on the

PC Board.

The ORBIT-6 stores information in 86 programming locations.

The data stored in any location is represented by numbers and/or letters. Some

locations require just one digit, while most require two. Others (e.g. those used to

store phone numbers and account numbers) may require several more digits.

It is not necessary to enter data into all 86 categories. Many locations have been

factory-programmed with default parameters.

Note that power can be removed from the ORBIT-6, as its memory does not require a

source of power to retain its information.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

No comments

Rokonet Orbit-6 User Manual Page 9