Rokonet Orbit-6 User Manual download pdf (Page 11)

Installer Manual

Viewing the Contents of a Location

It’s often necessary to check the data stored in a memory

location to be sure it’s correct. If improper data is found, it must

be corrected in order to obtain the desired system response. The

data in a location can either be a number (from 0-9) or a letter

(from A-F). Doing so takes advantage of the hexadecimal

numbering system. For our purposes, the characters A through F

will be referred to as hexadecimal digits.

Whenever the Installer Programming mode is active, the first 4

keypad’s Zone LEDs (1-4) are used to reveal each digit in a

selected location. By adding up the values assigned to the lit

LEDs, the contents of any location can be determined. See table

below.

ZONE LEDs ZONE LEDs

I.D.: 4 3 2 1 I.D.: 4 3 2 1

Value: 8 4 2 1 value: 8 4 2 1

0 off off off off 8 ON off off off

1 off off off ON 9 ON off off ON

2 off off ON off A ON off ON off

3 off off ON ON B ON off ON ON

4 off ON off off C ON ON off off

5 off ON off ON D ON ON off ON

6 off ON ON off E ON ON ON off

7 off ON ON ON F ON ON ON ON

EXAMPLE: Zone 4-ON Zone 3-off Zone 2-off Zone 1-ON TOTAL = 9

EXAMPLE: Zone 4-ON Zone 3-off Zone 2-ON Zone 1-ON TOTAL = B

Hexadecimal Digits

In some locations you may be

required to enter hexadecimal

digits A - F to do so see the next

table.

“A” is entered by pressing [STAY] + [1]

“B” is entered by pressing [STAY] + [2]

“C” is entered by pressing [STAY] + [3]

“D” is entered by pressing [STAY] + [4]

“E” is entered by pressing [STAY] + [5]

“F” is entered by pressing [STAY] + [6]

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

No comments

Rokonet Orbit-6 User Manual Page 11