Rokonet ORBiT-14 User Manual download pdf (Page 22)

User's Manual

Section 4: Arming and Disarming the

System

Arming

Arming your system enables its intrusion detectors to trigger an alarm when

violated. Remember, fire protection and the protection offered by the

keypad's emergency keys are always armed and always available. If your

system is equipped with environmental protection (for example, gas and/or

water level detection) it is always available too.

NOTE:

Before you arm your system, all of its zones must either be secured or bypassed.

The keypad's READY LED, if lit, indicates that all zones are secured. If the READY

LED is not lit, a numbered LED corresponding to the unsecured zone(s) will be

flashing. Before you can arm your system, the indicated zone(s) must be identified

and secured. If this is not possible, the affected zone(s) can be bypassed and will be

ignored by the system during the subsequent armed period. Recall that bypassing,

however necessary, reduces the system's degree of intrusion protection.

Away Arming

Away arming prepares all of the system's intrusion detectors to trigger an

alarm, if violated, and is used when leaving the premises empty.

STEP DESCRIPTION

Check the READY LED on your keypad. If lit or flashing, the

system is READY to be armed.

If NOT lit or flashing, the system is NOT ready to be armed. In

this case secure or bypass the violated zone(s) and then

proceed.

Enter your 4-digit User Code and press

NOTE:

If you make a mistake when entering your User Code, the keypad will

produce three short beeps. If so, re-enter the code correctly.

Leave the premises and close the door. The keypad will beep as

it counts down the Exit Delay period.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Rokonet ORBiT-14 User Manual Page 22