Rokonet ORBiT-14 User Manual download pdf (Page 3)

User's Manual

iii

Customer Information

RTTE Compliance Statement

Hereby, Rokonet Electronics Ltd, declares that ORBIT-14 (RP214MC0000A) with wired

accessories (including cables) is in compliance with the essential requirements and other

relevant provisions of Directive 1999/5/EC.

Telephone Connection (Ref.: FCC Part 68)

1. This equipment, Alarm Control Panel, brand named ORBIT-14 (RP214MA0000A),

complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA.

On the bottom panel of this equipment is a label, that contains among other

information, a product identifier in the format US:RKEAL10BRP214MA. If requested,

this number must be provided to the telephone company.

2. This equipment is designed to be connected to the telephone network using a terminal

block, which is Part 68 compliant and properly installed RJ31X connector. See

Installation Instructions for details.

3. The REN is used to determine the number of devices that may be connected to a

telephone line. Excessive RENs on a telephone line may result in the devices not

ringing in response to an incoming call. In most but not all areas, the sum of RENs

should not exceed five (5.0). To be certain of the number of devices that may be

connected to a line, as determined by the total RENs, contact the local telephone

company. The REN of alarm system is part of the product identifier that has the format

US:RKEAL10BRP214MA.

4. If the Alarm Control Panel causes harm to the telephone network, the telephone

company will notify you in advance that temporary discontinuance of service may be

required. If advance notice is not practical, you will be notified as soon as possible.

Also, you will be advised of your right to file a compliant with the FCC if it is

necessary.

5. The telephone company may make changes in its facilities, equipment, operations or

procedures that could affect the operation of the equipment. If this happens the

telephone company will provide advance notice in order for you to make necessary

modifications to maintain uninterrupted service.

6. If trouble is experienced with the Alarm Control Panel for repair or warranty

information please contact: Rokonet Industries USA Inc 2822 NW 79th Ave. Miami,

Florida 33122 USA, phone number 305 592 3820, URL: [email protected].

If the equipment is causing harm to the telephone network, the telephone company

may request to disconnect the equipment until the problem is resolved.

7. The control panel is described in the Installation Manual. Connection to telephone

company provided coin service is prohibited. Connection to party lines service is

subject to state tariffs.

8. Alarm Control Panel must be able to seize the telephone line and place a call in an

emergency situation. It must be able to do this even if other equipment (telephone,

answering system, computer modem, etc.) already has the telephone line in use. To

do so the alarm control panel must be connected to a properly installed RJ31X jack

that is electrically in series with and ahead of all other equipment attached to the same

telephone line. Proper installation is depicted in the figure below. If you have any

questions concerning these instructions, you should consult your telephone company

or a qualified installer about installing the RJ31X jack and Alarm Control Panel for you.

1 2 3 4 5 6 7 8 ... 41 42

Comments to this Manuals

No comments

Rokonet ORBiT-14 User Manual Page 3

Comments to this Manuals

Related products and manuals for Security access control systems Rokonet ORBiT-14