Rokonet ORBiT-14 User Manual download pdf (Page 27)

User's Manual

Section 5: Zone Bypassing

When an intrusion zone is not secured, the READY LED on your keypad will

not light, nor can the system be readily armed.

Noting which LED(S) are flashing in the keypad’s ZONES area can identify

the faulted intrusion zone. Bypassing a zone enables you to arm the system

even if a zone is open/not secured.

WARNING:

A bypassed zone may reduce the system's security capability.

Code Bypassing

To bypass such a zone(s) and cause it to be ignored by the system, enter

the following sequence correctly:

2-DIGIT

ZONE TO BE

BYPASSED

2-DIGIT

ZONE TO BE

BYPASSED

NOTES:

If you make a mistake when entering your User Code, the keypad will produce three

short beeps. Re-enter if necessary.

Enter a two-digit code for the zone number. For example, for zone five enter 05.

An additional zone(s) can be bypassed at the same time by adding its number to the

sequence. For example, to bypass Zones 2 and 3, press: [ ] + [ 1 ] + [USER

CODE] + [ 02 ] + [ 03 ].

The same sequence can “toggle” the bypass(es) during the disarmed period so that

they may be either applied or removed.

Press [#] or [✱] to approve or wait two seconds (timeout period).

Quick Bypass

If the system is programmed for Quick Bypass, you can follow the same

procedure as described above without entering the 4-digit User code or you

can use the following option for extra quick bypassing:

 To execute extra quick bypass:

Press the first digit of the zone number for at least 2 seconds, until a beep is

heard. After the beep enter the second digit of the zone number. For

example, to bypass zone 05:

[ 0 ] for 2 seconds + [ 5 ]

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

No comments

Rokonet ORBiT-14 User Manual Page 27