Rokonet Orbit-6 User Manual download pdf (Page 16)

Installer Manual

Location: 09 Installer Code II Default: 1206

Same as the Installer Code 1, but with a few limitations: It can't modify the "default

code", observe and modify the first installer's codes, modify any MS phone number,

nor observe & modify MS lock code.

Location: 10 Master Code Default: 1234

PURPOSE: to establish the keypad code for the system’s “chief user”; the

Master Code provides the following special privileges:

• to enter, modify, and delete the remaining nine User Codes

• to set the system's internal clock

• to perform certain system functions and tests

Note: the Master Code cannot be seen by the installer through the zone LEDs on the

keypad.

SYSTEM TIME: LOCATIONS 11-13

Location: 11 Exit Delay Default: 030

PURPOSE: to establish the system’s Exit Delay (the interval, in seconds, between

entering a User Code at the keypad and when the system actually arms).

Enter three digits between 001 and 255 seconds

Location: 12 Entry Delay Default: 060

PURPOSE: to establish the system’s Entry Delay (in an armed system, the interval, in

seconds, between the moment an entry door is opened and an alarm is triggered).

Enter three digits between 001 and 255 seconds

Location: 13 Bell Cutoff Time Default: 04

PURPOSE: to set the interval that the system’s external sounder(s) will operate before

it shuts off automatically.

Enter the number of minutes between 01 and 90

INTRUSION ZONE TYPES AND ZONE SOUNDS: LOCATIONS 14-21

Locations 14 through 21 are identical and are corresponding to Zones 1 through 6 or 8

(in the 8-zone keypad), respectively. Each of these locations contains two digits.

• the first digit: Contains the number used to represent the Type of Zone desired

• the second digit: Contains the number used to represent the sound produced

when in alarm

Note: 1. When using 6 zone keypad the system disregards zones 7 - 8.

2. When using 8 zone keypad, zones 7 - 8 must be connected to an EOL

resister when not in use.

Master Code

Installer Code

Sounder

Cutoff

Entry Delay

Exit Delay

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

No comments

Rokonet Orbit-6 User Manual Page 16