Rokonet Orbit-6 User Manual download pdf (Page 2)

Installer Manual

Customer Information

1. The ORBIT-6 (Model RP-206) complies with FCC Part 68 Rules. On the upper panel of this

product is a label that contains, among other information, the FCC Registration Number and

Ringer Equivalence Number (REN is 0.8B). If requested, this information must be provided to the

Telephone Company.

2. An FCC compliant telephone connector is provided with this equipment. This equipment is

designed to be connected to the telephone network or premises wiring using a connector, which

is Part 68 compliant.

3. If the ORBIT-6 (RP-206) is not operating properly, it may cause harm to the telephone network. If

so, the Telephone Company will notify you in advance that a temporary discontinuance of service

may be required. If advance notice is not practical, you will be notified as soon as possible. Also,

you will be advised of your right to file a complaint with the FCC if it is necessary.

4. The Telephone Company may make changes in its facilities, equipment, operations, or

procedures, which could affect the operation of the equipment. If this happens, the Telephone

Company will provide advance notice in order to enable you to make the necessary modifications

to maintain uninterrupted service. If the equipment is causing harm to the telephone network, the

Telephone Company may request that the equipment be disconnected until the problem is

resolved.

5. Connection to telephone company-provided coin service is prohibited. Connection to party line

service is subject to state tariffs.

6. If trouble is experienced with the ORBIT-6 (RP-206), for repair and warranty information, please

contact your supplier.

For service centers please see back cover.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced Radio/TV technician for help.

Changes or modifications to this unit not expressly approved by Rokonet, Ltd., could void the user's

authority to operate the equipment.

This equipment has been approved to Council decision 98/482/EC – “TBR 21” for pan-European single

terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences

between the individual PSTNs provided in different countries, the approval does not, in itself, give an

unconditional assurance of successful operation on every PSTN termination point.

In the event of problems, you should contact your equipment supplier in the first instance.

1 2 3 4 5 6 7 ... 36 37

Comments to this Manuals

No comments

Rokonet Orbit-6 User Manual Page 2

Comments to this Manuals

Related products and manuals for Security access control systems Rokonet Orbit-6